2007 CATERPILLAR D8T

2007

9,693

Used

For Sale: 2007 CAT D8T Dozer General: Manufacturer: Caterpillar Hour meter reads: 9,693 (A.O. 07/10/2025) Prefix: KPZ Build Date: 12/12/2006 Engine: C15, Turbocharged/Aftercooled, Tier 3. Flywheel Power: 310HP Transmission: 3F/3R (Top Speed Forward 6.6mph, Reverse 8.8mph) Blade: Semi-U. Ripper: 3 Shanks. Undercarriage: 65-75% 24" Single Grouser, height shows 2-1/4" EROPS: Heat/AC (AC works well). Notes: - Tractor runs and operates as intended. - No blow by detected. - Four rear ripper cylinders are from D8N. - Front right lift cylinder has slight seepage. Undercarriage overall in moderate wear condition: sprockets good, shoes 75% remaining, adjusters ~60% extended, pins visually round. No immediate action needed, but track chain wear is progressing—plan for maintenance when adjusters approach end of stroke. - Empire CAT installed new tracks in 2023. - Track adjuster piston: - - Left side: 3-3/8" - - Right side: 3-1/16" - - Estimated range left: 2 to 2-1/2". Peaks Performance performed the following work in October 2024: - Engine Fan System: Fan pressure sensor, steering charge filter, and torque converter temp sensor replaced. Wiring to fan solenoid and temp sensor repaired with new connectors. ECM settings calibrated to spec; fan speed set to 1444 RPM with 1600 PSI clip. - A/C System: Leaking hose replaced, system pressure-tested, vacuumed, and recharged. - Engine Mounts: Missing front right engine mount bolts installed; alignment corrected. - Owner purchased the tractor in November 2007 with approximately 3,000 hours. Dimensions: - Length: 19' (Tractor only), 23' (Ripper attached), 27' (Ripper & Blade attached) - Width: 9' 1" (Blade removed) 13' (Blade attached) - Height: 12' 3" - Tractor Weight: 75,000 lbs. - Blade Weight: 8,800 lbs. - Ripper Weight: 8,000 lbs - Total Weight: 91,800 lbs. Location: Winkelman, AZ

Semi U

91,800 lb

Yes

Multi Shank

Enclosed

Yes

Excellent

310 HP

23 ft

9 ft 1 in

12 ft 3 in

75,000 lb